|
The dimension must show decimal tolerances above each other
Enter the following :- 46.7m\+(1 space).5\-(2 spaces).2
The dimension is shown as follows:
The dimension must show the tolerances above each other
Enter the following :- 50.2m\/ (Backslash Forwardslash) 50m
The dimension is shown as follows:
The dimension must show the tolerances above and below the dimension line
Enter the following :- 50m\\ (Backslash Backslash) 49.9m
The dimension is shown as follows:
An alternative if space for the dimension is a problem
For dimensioning, where you know space will be a problem, but would really like the dimension to site above the line and not justified off to the left or right.
Enter the following : - 10.67m\/ (Backslash Forwardslash)
The dimension is shown as follows: (this gives the
desired effect of having a line feed, and the dimension not being offset).
You might also not want the "m" or the dimension unit in the dimension.
Click on the Setting Menu › Drawing Settings.
Click on the meter button. On the dialog that
appears remove the unit symbol.
All dimensions will now not show the unit symbol.
|
